วิธีการติดตั้งดูจากลิงค์ข้างล้างนี้ ให้ดาวโหลด์ไดร์เวอร์ตัวเก่ามาลง
http://wp.brodzinski.net/hardware/fake-pl2303-how-to-install/
USB to UART ที่ซื้อมาจากอเมซอล ดันเป็นเวอร์ชั้นเก่า window 10 มองไม่เห็นไดร์เวอร์
https://www.amazon.co.uk/gp/product/B00KAE2EL4/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1
Product Description
Adafruit USB to TTL Serial Cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB Serial conversion chip and at the end of the 36 inches cable are four wire - red power, black ground, white RX into USB port and green TX out of the USB port. The power pin provides the 5V at 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.
Because of the separated pin plugs, this cable is ideal for powering and connecting up to the debug/login console on the Raspberry Pi or BeagleBone Black. Connect the pins as shown to power the Pi or BBB and establish the RX/TX link. Then install the Windows XP/Vista/7 or MacOS X PL2303HX. A drivers on your computer and connect with a terminal program at 115200 baud. Windows 8 is not supported at this time. If you're using Windows 7 and you have issues, try this Prolific driver version 1.013. Also handy for hacking WiFi routers to install alternate OS's or nearly any other TTL port. This is easier to use than an FTDI cable in many cases because the wires are separated.
This cable is not good for Arduino re-programming such as a Boarduino, MENTA, Monochron, etc. Because it does not have the DTR/RTS wire necessary for initiating the bootloader reboot sequence.
Box Contains
1x USB to TTL Serial Cable
